Component Access/Removal
Integrated (
Integrated (
700-
700-
2) Series
2) Series
7-39
#3756780 - Revision D - July, 2005
Condenser Removal (All Base Units)
The condenser is secured to the unit tray by four rivets
that pass up through the unit tray into the condenser
side brackets.
NOTE: Before attempting to remove the condenser,
evacuate the refrigerant from the sealed system.
To access the condenser, the kickplate/grille will need
to be removed first and the unit tray will need to be slid
out. To slide the unit tray out, extract the two screws
that secure the tray to the unit, located at the front right
and left corners. Grab the front flange of the tray and
pull forward. (See Figure 7-100)
NOTE: It will be necessary to disconnect the compres-
sor electrical leads in order to pull the tray out far
enough to remove the condenser.
Begin removing the condenser by cutting the inlet and
outlet tubes to and from the condenser, approximately
one inch from the weld joints. Then, prop the front of
the unit tray up and drill out the four rivets securing the
condenser to the tray. (See Figure 7-101)
NOTE: Sweating the joints apart is not recommended
as this may induce moisture into the sealed system.
NOTE: The high-side filter-drier must be replaced
whenever replacing the condenser.
NOTE: To reattach the condenser to the unit tray, use
#10-24 X 3/8” bolts (#6200020) passing up through the
unit tray and condenser brackets with #10-24 Hex nuts
(#6150030) tightened down on top.
NOTE: When installing the replacement condenser, be
sure to thoroughly clean the tubing before brazing.
Figure 7-101. Condenser Removal
Tilt front of unit tray up
and drill out the four rivets.
(2 each side)
Condenser
Figure 7-100. Sliding Unit Tray Out
Screw
Screw
To Next Page
Loading...
Need help?
General
