14
SUB-ZERO INTEGRATED USE & CARE
CLEANING
CONDENSER CLEANING
F
or all Integrated models, the condenser is
located behind the kickplate/grille. To clean the
condenser area, remove the screws holding
t
he kickplate/grille in place. The kickplate/grille
will slide forward easily, giving you access to
the condenser area. Then using a soft bristle
brush, vacuum to remove dust and lint from
the condenser.
IMPORTANT NOTE:
To ensure efficient
performance of your Integrated unit, your
condenser must be cleaned every three to six
months under normal use. If you have pets in
your home, it may be necessary to clean the
condenser area more often.
Condenser location
Before cleaning, shut off power to the
unit at the electronic control panel. When
cleaning the condenser, wear gloves to
avoid injury from the sharp condenser
fins.
Failure to clean the condenser could
result in temperature loss or mechanical
failure or damage.
SOUNDS
Certain noises may be evident with the normal
operation of the unit. Surrounding acoustics
l
ike walls, floors and cabinets may affect the
sound level of your unit.
To Next Page
Loading...
Need help?
General
