Sub-Zero BI-42S Use And Care Guide

12 | Sub-Zero Customer Care 800.222.7820
FREEZER LIGHTING
Over-and-under models | Lighting is located in upper front
section of the freezer compartment. To remove the light
diffuser, gently compress the diffuser to release it from sup-
porting guides.
Side-by-side models | Freezer basket lighting is located
above the ice container. To access the light bulb, remove
the ice container and push the carrier assembly to the back
of the unit. The bulb will be accessible under the xed shelf
in front of the ice maker.
Dispenser models | Lighting above the ice container
is accessible by removing the ice container. Refer to ice
container removal on page 7. Once the container has been
removed, remove the light diffuser as described in overhead
lighting. Lighting below the ice container is accessible by
removing the light diffuser. To remove, press the plastic
lip up and pull the diffuser out of the supporting guides.
Freezer basket lighting is located below the xed shelf on
the back wall of the freezer. To access the light diffuser, rst
remove the freezer basket below the xed shelf. To remove
the light diffuser and access the light bulb, gently compress
the diffuser to release it from supporting guides.
CRISPER LIGHTING
Crisper drawer lighting is located behind the upper crisper
drawer and mounted to the back wall of the refrigerator.
To remove the light diffuser, remove the crisper drawer and
upper crisper shelf. Place both hands under the right and
left sides of the diffuser and push upward. Refer to the
illustration.
Interior Lighting
Interior lighting will illuminate when doors are open. Unique
40-watt appliance bulbs are used in the refrigerator and
freezer.
CAUTION
Turn power off at the control panel before replacing light
bulbs. Wear protective gloves when handling bulbs.
OVERHEAD LIGHTING
To replace light bulbs, remove the light diffuser. Slide the
light diffuser back until the slots drop past the bracket pegs.
Lower the light diffuser to remove. Refer to the illustration
below.
To reinstall, align slots with bracket pegs. Pull forward until
tabs engage pegs.
For glass door models, accent lighting can be turned on
and off by touching LIGHTS on the control panel. The
indicator will illuminate when accent lighting is activated.
OPERATION
Overhead lighting.
PEG
SLOT
Crisper lighting.

Sub-Zero BI-42S Specifications

General

Brand	Sub-Zero
Model	BI-42S
Category	Refrigerator
Language	English