WARNING
Built-In units are heavy and can be unstable when
attempting to install them. When moving a Built-In unit,
keep the doors and drawers taped closed. The anti-tip
components supplied with Built-In units must be used as
specified in the installation guide. The fr
ont leveling legs of
a Built-In unit must be extended to the
floor to complete
the installation. If a Built-In unit were to tip and fall, it could
cause serious injury or death!
CONTENTS
4 Bolt, Tensilock
5
/
16
-18 ×
3
/
4
1 Clip, cord plastic
5
/
16
×
1
/
2
6 Screw, #8-32 ×
1
/
2
pan head
4 Threaded insert,
5
/
16
-18 hx opn
1 Trim, dual install center long
1 Bracket, dual install bot
4 Screw,
5
/
16
×
3
/
4
thread-forming
1 Bracket, dual install top
3 Bracket assembly, dual trim
1 Threaded insert, install tool
1 Heater assembly, dual installation
1 Shim, assembly main frame
6 Nut, 10-24 hex flange lock
1 Machine screw, #10-24 × 2
1
/
4
1 Nut, #10-24 with nylon insert
1 Instructions, dual installation
INSTALL THE HEATER
Note: The heater assembly MUST be attached to the right
side of the left-hand unit.
1
Clear the foil from the mounting holes of the heater
assembly.
2
Place the heater against the right-hand side of the unit
with wires up and foil side in, positioning the heater 2”
(51 mm) from the top edge of the cabinet and 1” (25
mm) from the rear edge of the cabinet.
3
Using the heater as a template, mark the heater
mounting holes on the cabinet with a pencil, then
remove the heater.
4
Drill a
7
/
64
" (3 mm) hole at each marked location.
Note: To avoid drilling through the inner liner, use a
short drill bit inserted into the drill chuck so that no
more than
1
/
2
” (13 mm) to
3
/
4
” (19 mm) of bit is
protruding.
5
Attach the heater to the unit using the #8-32 ×
1
/
2
" pan
head screws into the drilled holes.
6
Remove the four-prong safety plug from the panel-
mounted
four-prong receptacle at the rear side of
the power cord box.
7
Connect the heater’s four-prong plug to the receptacle.
8
Attach the
5
/
16
" ×
1
/
2
" plastic cord clip in a convenient
location near the water
filter.
9
Route the heater wires through the plastic cord clip and
any other available wire clips.
1”
2”
Power Cord Box and
4-Prong Heater Plug
Connection (Rear View)
INSTALL THE CENTER TRIM
Note: Assemble the center trim piece and trim brackets
first, then attach the trim to the right-hand side of the left-
hand unit.
1
Attach the three L-shaped dual trim bracket assemblies
to the dual install center trim piece using the nuts
pr
ovided. Do not tighten the nuts at this time.
Built-In Series Dual Installation Kit
subzero.com 800.222.7820
7004565 REV. E 06/2018
Page 1 of 4
*7004565$REV.$E*
To Next Page
Need help?
General
