CONTENTS
1 Heater
2 Guard, edge
1 Tape
4 Clip, center
4 Screw, #8 x
1
/
2
"
1 Trim, center
1 Wire, ground
1 Bushing, plastic
UNDERCOUNTER DUAL INSTALLATION
1 Remove the paper backing from the tape on the back
of the heater panel.
2 Place the heater on the left side of the unit on the
right.
3 Align the heater with the top of the unit, and press
firmly to secure.
4 Install edge guard on the bottom of the heater panel
where wires pass. Trim the edge guard to fit.
5 Clip the ground wire to the opening and the heater
panel.
6 Remove the screws from the back panel and remove
the back panel.
7 Remove the unused connector.
8 Place the leads from heater into the correct location
on the connector.
Note: Wire location is model-specific. Refer to the
chart for proper placement.
WIRE PLACEMENT
MODEL WIRE PLACEMENT
Combination Refrigerator/
Freezer
1 and 2
All Other Models 2 and 4
9 Connect the heater connector to the connector on the
unit.
10 Install the back cover using the existing screws.
11 Install the plastic bushing around the heater wires,
then insert the bushing into the hole on the back
panel.
12 Clip the ground wire to the bottom of the heater and
to the square hole on the back cover
.
13 Install tape to the front edge of the heater.
14 Insert both units into the opening.
Designer Series Undercounter Dual Installation
subzero.com 800.222.7820
9028883 REV-A 08/2020
Page 1 of 2
*9028883$REVB*
To Next Page
Need help?
General
