5-6
Audio
T Power switch and volume/bass/treble/fader/
balance control (PWR/VOL)
The dial (1) is used for both power (ON/OFF) and vol-
ume control. The radio is turned ON and OFF by push-
ing the dial and the volume is controlled by turning the
dial.
V Tone and balance control
The “VOLUME” control knob normally function as vol-
ume control. This knob become a control for Treble,
Bass, Fader or Balance when you select the appropri-
ate audio mode.
Choose desired volume level for each mode by turning
the “VOLUME” control knob. The control function re-
turns to volume control mode after about 5 seconds.
To change control modes: To change control
modesEach brief press of the “AUDIO” button chang-
es control modes in the following sequence starting
from volume control mode. (When the radio is first
turned on, the control mode is in the volume control.)
Volume
(VOL)
Bass
(BAS)
Treble
(TRE)
Balance
(BAL)
Fader
(FAD)
To Next Page
Loading...
