1-25
Seat, seatbelt and SRS airbags
– CONTINUED –
0
1. Insert a key or other hard pointed object into the
slot in the connector (buckle) on the right-hand side
and push it in, and the connector (tongue) plate will
disconnect from the buckle.
2. Allow the retractor to roll up the belt. You should
hold the webbing end and guide it back into the retrac-
tor while it is rolling up. Neatly store the tongue plates
in the recess in the retractor and then insert the con-
nector (tongue) plate into the slot located at the front
of the recess.
HS1063BA
HS1064BA
HS1065BA
To Next Page
Loading...
