7-52 Starting and operating
The light illuminates when the “CRUISE”
main switch is pressed.
NOTE
. If you press the “CRUISE” main
switch button while turning the ignition
switch “ON”, the cruise control func-
tion is deactivated and the cruise
control indicator light flashes. To re-
activa te the cruise control function,
turn the ignition switch back to the
“Acc” or “LOCK” position, and then
turn it again to the “ON” position.
. If this indicator light and the CHECK
ENGINE warning light/malfunction in-
dicator lamp flash simultaneously dur-
ing driving, have the vehicle checked
by your nearest SUBARU dealer.
& Cruise control set indicator
light
WRX STI
Turbo models except WRX STI
Non-turbo models
The cruise control set indicator light
illuminates when the ignition switch is
turned to the “ON” position and goes out
after approximately 3 seconds.
The light illuminates when vehicle speed
has been set.
To Next Page
Loading...
Need help?
General
