102
1-4. Opening and closing the windows
BRZ_EGE
■ The power windows can be operated when
The push-button ignition switch is in “ON” mode.
■ Operating the power windows after turning the engine off
The power windows can be operated for approximately 40 seconds even
after the push-button ignition switch is turned to “ACC” mode or turned off.
They cannot, however, be operated once either door is opened.
■ Jam protection function
If an object becomes caught between the window and the body, window
travel is stopped and the window is opened slightly.
■ When the power window does not close normally
If the jam protection function is operating abnormally and a window cannot
be closed, close all the doors perform the following operations using the
power window switch on the relevant door.
After stopping the vehicle, the push-button ignition switch is turned
to “ON” mode.
Hold the power window switch in the one-touch closing position two
consecutive times.
Hold the power window switch in the one-touch closing position
once again and continue holding for 1 second or more after the win-
dow closes completely.
If you push the power window switch to the opening position while the win-
dow is moving, start again from the beginning. If the window continues to
close but then re-open slightly even after performing the above procedure
correctly, we recommend that you have your vehicle inspected by any autho-
rized SUBARU dealer or repairer, or another duly qualified and equipped
professional.
STEP
1
STEP
2
STEP
3
To Next Page
Loading...
