Subaru RGV12100 - How-To Maintenance; Engine Oil and Filter Maintenance

ENGLISHFRANÇAISEESPAÑOL
-
29
-
9. "HOW-TO" MAINTENANCE
ENGINE OIL CHANGE
■
Initial oil change
・・・・・After 20 hours of operation
■
Thereafter
・・・・・ Every 100 hours of operation
1. When changing oil, stop the engine and
loosen the drain plug.
2. Re-install the drain plug before refilling
oil.
3. Refer to the recommended oil table on
page 6.
4. Always use the best grade and clean
oil. Contaminated oil, poor quality oil
and shortage of oil cause damage to
engine or shorten the engine life.
ENGINE OIL FILTER
REPLACEMENT
■
Initial engine oil filter replacement
should be performed after 20 hours
of operation. Thereafter replace the
engine oil filter every 200 hours.
■
When installing a new oil filter, apply
oil to O-ring, attach the oil filter in
position and tighten 2/3 turns by
hand or with wrench after touching
the O-ring to the sealing surface of
engine.
■
Run the engine for a minute ; stop
the engine and check for oil leakage
around the oil filter and recheck the oil
level.
Oil filter
Oil capacity (Upper level) : L(U.S. gal)
RGV12100 . . . . . . . . . . . . . . 1.55 (0.41)
RGV13100T . . . . . . . . . . . . . 1.55 (0.41)
To prevent injury, pay attention
to the spilled hot engine oil
when replacing engine oil filter.
[
CAUTION
]
Oil drain plug
(On both side)
OIL FILLER CAP
RGV13100usGU7306.indd29RGV13100usGU7306.indd29 2012/01/2315:22:522012/01/2315:22:52