Subaru RGX6500/E - Using Electric Power Output; AC Application, Receptacles, and GFCI Testing

ENGLISHFRANÇAISEESPAÑOL
-
14
-
(a) Make sure the pilot lamp is turned on.
(b) Turn off the switch (es) of the electrical
appliance (s) before connecting to the
generator.
(c) Insert the plug (s) of the electrical
appliance(s) into the receptacle.
(1) AC APPLICATION
USING ELECTRIC POWER
■
Make sure that the appliance is switched OFF before connecting it to
the generator.
■
Do not move the generator while it is running.
■
Be sure to ground the generator if the connected appliance is
grounded. Failure to ground unit may lead to electrical shock.
■
Check the amperage of the receptacles used referring to TABLE 1, and be
sure not to take a current exceeding the specified amperage.
■
Be sure that the total wattage of all appliances dose not exceed the rated
output of the generator.
WARNING
RGX7500usGU7220.indd14 2011/06/1521:48:58