22
Function settings
A SUBARU dealer can change the settings of the functions shown in the following table to meet your personal requirements. Contact
the nearest SUBARU dealer for details. For details, refer to “Multi function display” F3-45.
Item Function Possible settings Default setting
Alarm system Alarm system Operation/Non-operation Operation
Monitoring start delay time (after closure of doors) 0 seconds/30 seconds 30 seconds
Impact sensor operation (only models with shock
sensors (dealer option))
Operation/Non-operation Non-operation
Passive arming (models without “keyless access with
push-button start system”)
Operation/Non-operation Non-operation
Dome light and map lights (models with moonroof)
illumination
ON/OFF OFF
Keyless access (if equipped) Hazard warning flasher* Operation/Non-operation Operation
Audible signal* Operation/Non-operation Operation
Volume of the audible signal 1 - 7 5
Door unlock selection function (driver’s door unlock) Driver’s door only/All doors Driver’s door only
Remote keyless entry system Hazard warning flasher* Operation/Non-operation Operation
Audible signal* Operation/Non-operation Operation
Volume of the audible signal 1 - 7 5
Key lock-in prevention Key lock-in prevention Operation/Non-operation Operation
Defogger and deicer system for models
with the automatic climate control sys-
tem*
Rear window defogger, outside mirror defogger and
windshield wiper deicer
Operation for 15 minutes/
Continuous operation
Operation for 15
minutes
Dome light Operation of dome light/map light OFF delay timer OFF/10 seconds/20 sec-
onds/30 seconds
30 seconds
Map light (models with moonroof)
Battery drainage prevention function Battery drainage prevention function Operation/Non-operation Operation
To Next Page
Loading...
Need help?
General
