4
Installation
Before Putting Your Appliance Into Use
• Remove all inner and outer packaging components.
• Verify that none of the following are missing:
o Removable shelves
o 1 operating manual
o Set of 2 keys
• Allow the device to stand upright for a minimum of 2 hours before connecting it to a power
supply. This minimises the risk of refrigeration system malfunction due to transport handling.
• Ventilation Clearance - Maintain a 5-10cm clearance at the sides and back and at least a 5cm
clearance at the top.
• Clean the inner surfaces of the unit using a soft cloth and warm soapy water.
• Position the unit on a sufficiently sturdy surface capable of supporting its fully filled weight.
• Ensure the unit is level by adjusting the front feet underneath, ensuring stable placement.
• Install the appliance away from direct sunlight and heat sources. Prolonged exposure to sunlight
can damage the unit's coating, and excess heat can elevate power consumption. Extreme ambient
temperatures may effect proper operation.
• The unit is not intended for installation in unheated buildings, outbuildings, or garages.
• This unit is designed exclusively for indoor use.
• Caution: Keep the unit away from any substance that may cause combustion.
• Ensure that the drip tray above the compressor is properly positioned before connecting the unit
to the power supply.
To Next Page
Loading...
