Need help?Do you have a question about the Subzero BI Series and is the answer not in the manual?
General| Water Filtration | Yes |
|---|---|
| Water Filter Indicator | Yes |
| Ice Type | Crescent |
| Ice Production | Up to 50 lbs per day |
| Voltage | 115 V AC |
| Refrigerant | R134a |
Describes the function of each icemaker component, illustrated in a diagram.
The ice mold is filled with water, thermostat is open, and no components are energized.
Water turns to ice, thermostat closes, heater and motor energize, ejector turns.
Holding switch powers motor, heater energized, shut-off arm rises.
Ice releases, ejector rotates cubes, motor/heater energized, shut-off switch trips.
Water valve switch trips, holding switch trips, and motor restarts.
Water valve switch trips, holding switch trips, and motor restarts again.
Mold heater warms thermostat, thermostat opens, heater de-energizes.
Water valve switch trips, holding switch trips, thermostat open, motor doesn't start.
Ice production can be stopped via the control panel or by positioning the ice-level arm.
Explains bypassing the 45-minute dwell and manual start procedure using the drive gear.
Steps for testing the icemaker, checking continuity, and wiring.
Potential causes and checks for reduced or absent ice production.
Addresses issues related to water filling the ice mold correctly.
Troubleshooting for ice overflow, blockages, or incorrect cube size.
Diagnosing and resolving issues with ice cube formation.
Steps to address the condition where too much ice is produced.
To Next Page
