Icemaker Information
6-9
#7005333 - Revision C - September, 2010
Built-In (BI) Series
Built-In (BI) Series
MANUALLY STARTING THE ICEMAKER
NOTE: To allow ice to freeze fully and reduce effects of
low water pressure, the electronic control disables the
icemaker system for forty-five (45) minutes after each
ice harvest. To bypass this 45 minute dwell for service
purposes, press the the “ICE MAKER” key at the con-
trol panel to switch the system OFF, then again to
switch it back ON.
Manual S
tart Procedure:
1. Pry the icemaker front cover from the support using
a flat-blade screwdriver or coin.
2. With a flat-blade screwdriver, turn the drive gear
counterclockwise until the holding switch is activat-
ed, completing the circuit to the drive motor (this
will be about a 1/8 turn). (See Figure 6-13) The
icemaker will then complete its cycle automatically.
NOTE: If after 1/4 turn the icemaker is not running
on its own, it may be in the 45 minute dwell period
or there is an electrical or mechanical problem.
Figure 6-13. Manually Start Icemaker
To Next Page
Loading...
