1.18 Drawbar installation
02250216-783 R02
Subject to EAR, ECCN EAR99 and related export control restrictions. 51
185 T4F Kubota Parts List Manual 1: Parts List
Key Part number Qty Description Notes
1 02250094-269 1 CHAIN, 1/4 X 72 W/2 EZ3 HOOKS
2 02250100-538 1 CONNECTOR, DELTA-SHAPED CHAIN 1/4"
3 837808-125 8 WASHER, SPRLOCK REG PLTD 1/2"
4 838208-112 8 WASHER, PL-B REG PLTD 1/2"
5 875608-125 8 CAPSCREW, HEX 1/2-13 X 1 1/4
Drawing notes
A1 REMOVE SHIPPING SUPPORT FROM THE COMPRESSOR AND DRAWBAR.
A2 SLIGHTLY LOOSEN THE DRAWBAR PIVOT BOLTS. DO NOT REMOVE THEM.
A3
CAREFULLY SWING THE DRAWBAR TO ITS DOWN POSITION. INSTALL AS SHOWN WITH PROVIDED HARDWARE. TORQUE ALL 8 OF THE 1/2" BOLTS TO 57 FT-
LBS. NOTE: THE BOLTS ARE FRAME NUTS TO BE CLEAN AND FREE OF OIL. RETIGHTEN THE DRAWBAR PIVOT BOLTS.
A4 PUT JACK IN DOWN POSITION AND REMOVE YOUR MACHINE SUPPORTS.
A5 INSTALL THE SAFETY CHAIN THROUGH THE DRAWBAR HOLES AND SECURE WITH THE DELTA SHAPED CONNECTOR.
A6 MOVE THE TOWING EYE AND ITS HARDWARE TO DESIRED POSITION.
WARNING
WARNING! SUPPORT FRONT END OF MACHINE
WITH STURDY JACK STAND(S) SO DRAWBAR IN
THE UP POSITION IS 2 TO 3 INCHES OFF THE
GROUND. DO THIS BEFORE REMOVING THE
DRAWBAR SHIPPING SUPPORT.
To Next Page
Loading...
