Section 6
185 T3 Kubota User Manual 6: Noise Control
02250223-054 R01
Subject to EAR, ECCN EAR99 and related export control restrictions. 49
Noise Control
6.1 Noise emissions warranty
Sullair warrants to the ultimate purchaser and each sub-
sequent purchaser that this air compressor was
designe
d, built and equipped to conform at the time of
sale to the first retail purchaser, with all applicable U.S.
E.P.A. and/or any Federal, State or Local noise control
regulations.
This warranty is not limited to any particular p
art, compo-
nent, or system of the air compressor.
Defects in the
design, assembly, or in any part, component, or system
of the compressor which, at the time of sale to the first
retail purchaser, caused noise emissions to exceed Fed-
eral standards are covered by this warranty for the life of
the
air
compressor.
6.2 Tampering with the noise control
system is prohibited
Federal Law prohibits the following acts or the causing
thereof:
1. The removal or rendering inoperative by any
person
s, other than for purposes of mainte-
nance, repair, or replacement, of any device
or element of design incorporated into any
new compressor for the purpose of noise
control prior to its sale or delivery to the ulti-
mate purchaser or while it is in use.
2. The use of the compressor after such device
or element of design has been removed or
rendered inoperative by any person.
Among those acts included in the prohibition against tam-
pering are the acts listed below:
1. Removal or rendering inoperative any of the
following:
•
Engine exhaust
system or parts thereof
• Compressor air intake system or part
thereof
• Enclosure of part thereof
2. Removal of any of the following:
• Vibration isolators
• Control silencer
•Floor panel
•Fan shroud
• Acoustical materials including fiberglass
foam or foam tape
3. Operation with canopy doors open for any
purpose other than starting, stopping, adjust-
ment, repair, replacement of parts or mainte-
nance.
To Next Page
Loading...
