85
375 Caterpillar Standard and Aftercooled/Filtered Operator’s Manual and Parts List
ILLUSTRATIONS AND PARTS LIST
7.14 INSTRUMENT PANEL & PARTS (CONTINUED)
Key Description Part Number Note Quantity
1 gauge, pressure air 0-300 2" 02250044-361 1
2 gauge, volt-meter 12 volt 2" 02250044-366 1
3 gauge, temp mech 72" 140-300 sf 02250050-514 1
4 gauge, pressure mech 0-100psi 2" 02250050-516 1
5 hour-meter, 12-24vdc 10000hr 2" 02250050-517 1
6 tee,m run 3/8"tube x 1/4"npt 02250099-615 2
7 elbow, 90 3/8"tube x 1/4"npt m 02250099-626 2
8 tube,nylon .375"od x .050w black (ft) 02250099-630 2
9 gauge, temp mech 48" 140-300 sf 02250102-619 1
10 controller, 185/375 shutdown module (ssam) 02250126-682 1
11 lense, cliplite led 02250129-189 1
12 panel, instrument plastic ssam 02250129-190 1
13 decal,dual pressure 185-375 ssam 02250130-630 (I) 1
14 decal,starting aid 185-375 cat 02250130-631 1
15 harness, voltmeter 125-425 jd/cat 02250130-635 1
16 decal,group full gauge (ssam) 02250131-486 1
17 switch, engine ignition 12-volt 02250132-883 1
18 valve, ball 2-way 1/4"npt 02250136-999 2
19 elbow, 90 f 3/8"tube x 1/4"npt 02250137-033 1
20 cover, access ssam molded abs 02250137-265 1
21 harness, wire 375-425 cat tier ii 02250154-329 (II) 1
22 switch, starter push-button 040038 1
23 screw, tc-f rd hd #6-32 x 1/2 835700-050 2
24 washer, pl-b reg pltd #6 838200-045 2
25 bushing,red pltd 1/4 x 1/8 867100-005 1
(I) 300HH and 375HH models only
(II) Use P/N 02250144-353 for replacement of glow plug relay, P/N 02250153-875 for replacement of starter relay and P/N
02250155-383 for replacement of shutdown relay.
To Next Page
Loading...
