6: Maintenance ST18 & ST22 (U.S.A. & Mexico) Operation & Maintenance Manual
88291013-137 R05
32 Subject to EAR, ECCN EAR99 and related export control restrictions.
7. Install the new fluid/air separator element
and gasket assembly.
8. Reassemble in reverse order, carefully
adjusting the purge oil return line tube so it
has the correct clearance from the separator
element base (see Section 6.4.5: Purge oil
return line filter maintenance).
9. Evenly tighten the separator cover bolts.
10. Re-tension the separator cover bolts after
the compressor has reached operating tem-
perature.
Figure 6-4: Fluid/air separator tank
1. Fluid/air separator element
1
1
Element part number: 02250121-500
CAUTION
Do not remove the staples incorporated into the
gaskets.They maintain a ground contact with the
separator.
To Next Page
Loading...
