Section 7
ILLUSTRATIONS AND PARTS LIST
43
7.3 COMPRESSOR, FRAME AND DRIVE - 150-200HP/ 113-150KW
key part
number description number quantity
1 motor, 200 horse power 230/460/60 2p dpee (I) -1
2 drawing, tube&ftg-d321165d vac w/pu (II) 02250126-462 1
3 guard, coupling 225907 1
4 lug, lifting 25 series 250008-361 4
5 hub, coupling e50 2-3/4”dia 250026-446 1
6 frame, base rsvs32-200 250039-529 1
7 support, motor rsvs32-200 250039-530 2
8 element, coupling e50 406631 1
9 hub, coupling rex e-50 2-3/8” 407988 1
10 nut, hex pltd 1/2-13 825208-448 16
11 capscrew, hex gr5 3/4-10 x 4 1/2 828612-450 4
12 capscrew, hex gr5 3/8-16 x 1 1/4 829106-125 3
13 capscrew, hex gr5 1/2-13 x 2 829108-200 16
14 capscrew, hex gr5 7/8-9 x 4 829114-400 4
15 washer, spr lock reg pltd 1/2 837808-125 16
16 washer, spr lock reg pltd 3/4 837812-188 4
17 washer, spr lock reg pltd 7/8 837814-219 4
18 washer, pl-b reg pltd 3/8 838206-071 3
19 washer, pl-b reg pltd 3/4 838212-112 8
20 washer, pl-b reg pltd 7/8 838214-174 4
21 nut, hex 3/4-10 pltd 866512-665 4
(I) Drive motor part number will vary based on horsepower and voltage variation.
(II) There is an exchange program whereby a remanufactured vacuum unit can be obtained from Sullair
representatives or the factory at less cost than the owner could repair the unit. For information
regarding the unit exchange program, contact your nearest Sullair representative or the Sullair
Corporation.
The shaft seal is not considered part of the vacuum unit in regard to the 2 year warranty. The normal
Sullair parts warranty applies.
PLEASE NOTE: WHEN ORDERING PARTS, ALWAYS INDICATE SERIAL NUMBER OF VACUUM
To Next Page
Loading...