Sullair VS16 30HP Series - Section 7 ILLUSTRATIONS AND PARTS LIST

TABLE OF CONTENTS
Section 6
MAINTENANCE
(continued) 50 CONTROL SYSTEM ADJUSTMENT
51 FLUID RETURN/SIGHT GLASS MAINTENANCE
51 DRIVE COUPLING INSTALLATION
51 6.8 TROUBLESHOOTING - INTRODUCTION
51 6.9 TROUBLESHOOTING - GUIDE
Section 7
ILLUSTRATIONS
AND PARTS LIST
55
7.1 PROCEDURE FOR ORDERING PARTS
56 7.2 RECOMMENDED SPARE PARTS LIST
58 7.3 FRAME, MOTOR, COMPRESSOR AND PARTS -
30-40HP/22-30KW
62 7.4 FRAME, MOTOR, COMPRESSOR AND PARTS -
VS-16 50HP/37KW
66 7.5 AIR INLET SYSTEM
70 7.6 DISCHARGE SYSTEM - 30-40HP/22-30KW
72 7.7 DISCHARGE SYSTEM - 50HP/37KW
76 7.8 COOLER ASSEMBLY - AIR-COOLED
78 7.9 COOLER ASSEMBLY - WATER-COOLED
80 7.10 FLUID PIPING SYSTEM - AIR-COOLED
82 7.11 FLUID PIPING SYSTEM - WATER-COOLED
84 7.12 WATER PIPING SYSTEM
86 7.13 CONTROL SYSTEM
88 7.14 CONTROL SYSTEM - DUAL CONTROL
90 7.15 CONTROL SYSTEM - DUAL CONTROL
WITH ANNUNCIATOR
94 7.16 SULLICON CONTROL SYSTEM
96 7.17 CONTROL PANEL - SINGLE CONTROL
98 7.18 CONTROL PANEL - DUAL CONTROL
100 7.19 ENCLOSURE - 30-40HP/22-30KW AIR-COOLED
102 7.20 ENCLOSURE - 50HP/22-37KW AIR-COOLED
104 7.21 ENCLOSURE - 30-40HP/22-30KW WATER-COOLED
106 7.22 ENCLOSURE - 50HP/37KW WATER-COOLED
108 7.23 DECAL GROUP
114 7.24 DECAL LOCATIONS - AIR-COOLED (TYPICAL)
116 7.25 DECAL LOCATIONS - WATER-COOLED (TYPICAL)
118 7.26 DECAL LOCATIONS - CONTROL BOX INTERIOR
120 7.27 WIRING DIAGRAM - VS-16 MFV SINGLE
CONTROL ANNUNCIATION
Continued on next page