Sulzer Mixpac DP2X 200

Questions and Answers

M
Mary MooreAug 10, 2025
What to do if Sulzer Mixpac DP2X 200 Dispenser won't discharge material?
- J
  John LyonsAug 10, 2025
  If your Sulzer Dispenser isn't discharging material, it could be due to a couple of reasons. First, the material might have cured in the mixer; if so, replace the mixer, referring to the mixer open-time in the technical data sheet for the materials you're dispensing. Alternatively, the pressure might not be high enough. Try gradually increasing the pressure by turning the pressure regulation valve.
J
Jamie MooreAug 15, 2025
Why is my Sulzer Dispenser making a leaking air noise?
- R
  Rebecca WeissAug 15, 2025
  A leaking air noise from your Sulzer Dispenser could be due to several reasons. It's possible that the inlet pressure is too high, causing the safety valve to blow off; in this case, check and reduce the inlet pressure to an adequate level. Another possibility is a leakage at the compressed air connection; check and tighten the adapter. If the air leakage is coming from inside the handle, send the device to the manufacturer or an authorized service station for inspection.
D
David DawsonAug 20, 2025
What to do if dispensing is interrupted on my Sulzer Mixpac DP2X 200?
- G
  Gary GreeneAug 21, 2025
  If dispensing is interrupted while using your Sulzer Dispenser, the compressed air supply may have been interrupted. Check the compressed air supply pressure and the connection to the dispenser.
A
Anthony HillAug 26, 2025
How to fix plunger discs if they cannot enter the cartridge on Sulzer Mixpac DP2X 200?
- K
  Katherine SuttonAug 26, 2025
  If the plunger discs cannot enter the cartridge on your Sulzer Dispenser, consider these possibilities: * The cartridge might not be fully inserted in the cartridge holder. Check that the correct cartridge holder is installed and is not damaged, and push the cartridge fully down into the cartridge sleeve. * There might be foreign matter in the cartridge guide. Remove any foreign matter, but do not use sharp tools. * The wrong diameter of plunger discs might be installed. Check that you're using the correct diameter and change the plunger discs if necessary.
J
Jane RiveraAug 30, 2025
What to do if cartridge cannot be removed from Sulzer Dispenser?
- A
  Alexis JonesAug 30, 2025
  If the cartridge cannot be removed from your Sulzer Dispenser, it might be because the plunger discs are still in position inside the cartridge. Fully retract the plungers by using the retract button, and check the dispense volume indicator.
C
Collin CortezSep 4, 2025
Why is the dispensing speed uneven on my Sulzer Dispenser?
- E
  Ernest HuynhSep 4, 2025
  If you're experiencing uneven dispensing speed with your Sulzer Dispenser, it could be due to foreign matter in the driving unit or damaged sealing. Send the device to the manufacturer or an authorized service station for inspection. Never use solvents to clean the air path.