37
COMMON
Table 10 Items to check during initial start - up and break - in period
Is abnormal
sound or
vibration generated ?
(1) Is the housing deformed because the installation surface is not flat ?
(2) Is insufficient rigidity of the installation base generating excessive noise ?
(3) Is the shaft center aligned with the driven machine ?
(4)
Is the vibration of the driven machine transmitted to the gearmotor ?
Is the surface
temperature of the
gearmotor or reducer
abnormally high ?
(1) Is the voltage rise or drop substantial ?
(2) Is the ambient temperature too high ?
(3) Does the current flowing to
the gearmotor exceed the rated current
shown on the rating plate ?
· If any abnormality is found, stop operation and contact our nearest agent, distributor, or sales office.
· In the initial operation or right after exchange of the brake lining, specified braking torque might not be
outputted. When this happens, under the least loading, turn the power switch on and off to rub the
friction sides together.
· Because of the brake structure, rubbing noise of the lining might be made, which has no problems with
the performance.
7. Operation
To Next Page
Loading...