F Series Manual
2
1.1.1.3 Safety symbols on the machine
Safety labels are used on some parts of the machine. They are explained below.
Caution
Servicing instructions are for use by qualified service personnel only.
To reduce the risk of electric shock do not perform any servicing other
than that contained in the operating instructions unless you are qualified
to do so.
Contains Class 2 laser. Do not stare into the beam.
Complies with CFR Title 21, Chapter I, Subchapter J, Sections 1010.2,
1010.3, 1040.10 and 1040.11 in effect at the date of manufacture.
Use of any controls, adjustments or procedures other than those specified
herein may result in hazardous radiation exposure.
Caution
Sharp edges.
Touching the tools with bare hands may cause injury. Do not touch.
Moving parts.
Keep body parts out of the motion path.
This equipment is not suitable for use in locations where children are likely
to be present.
This equipment is not intended for use by children.
Avoid touching the moving parts and entering the cutting area with the
hands, clothing, jewelry or hair.
Unplug this equipment when not used for an extended period of time.
Caution
Hot surface.
Do not touch marked parts.
Warning
In certain cases, eye and/or ear protection must be worn.
Make sure to observe all the caution labels on the table.
There are no user-serviceable parts inside. For servicing refer to qualified personnel only.
Turn off the table and contact a service representative in any of the following cases.
• There is visible mechanical damage.
• The power cord is damaged.
• The table (or parts of it) have been damaged by an impact
• Liquid was spilt on the table.
• There is a strange noise, smoke or an unusual smell coming from the table.
To Next Page
Loading...
