Need help?Do you have a question about the SummaSign Pro T750 Pro and is the answer not in the manual?
General| Cutting Width | 750 mm |
|---|---|
| Max Cutting Speed | 1000 mm/s |
| Media Thickness | 0.05mm - 0.25mm |
| Weight | 27 kg (60 lbs) |
| Cutting Force | 0-400 grams |
| Maximum Media Width | 85 cm (33 in) |
| Contour Cutting | Yes |
| Cutting Speed | up to 1000 mm/s |
| Repeatability | ± 0.1 mm |
| Connectivity | USB |
| Interface | USB |
| Power Requirements | 100-240 V, 50/60 Hz |
Overview of the SummaSign Pro T-series cutters, key features, and manual scope.
Detailed specs for cutter, media, firmware, performance, environmental, and electrical aspects.
Lists available accessories and consumables for SummaSign Pro T-series models.
Description of rear panel components and front panel controls of the cutter.
Procedures for powering up, earthing, and installing various tools like knives and pens.
Instructions for positioning pinch rollers, feeding, and loading media onto the cutter.
Details the SummaSign Pro T-series cutter's control panel layout and functions.
Explains on-line, off-line, and local operation modes for cutting and plotting.
Access to submenus for configuring cutter operating parameters and settings.
Configuration for concatenation, smoothing, emulate, tool, units, addressing, and communication.
Procedures for accessing and performing internal diagnostic tests on the cutter.
Specialized procedures for field service personnel, including language, ROM, service plots, and hardware tests.
Instructions for cleaning drive system, sensors, and nose piece to ensure optimal cutter performance.
Guide for changing the cutter's operating voltage and fuse settings.
Overview of RS-232-C serial communication and system setup for various operating systems.
Pin assignments for serial/parallel connectors and available serial signals.
Introduction to contour cutting and handling design irregularities.
Steps for creating designs, placing cross-marks, and printing for contour cutting.
Loading cutter, setting parameters, registering cross-marks, and performing the contour cut.
Lists duly certified vinyl types for use with SummaSign Pro T-series cutters.
To Next Page
