SummaSign Pro T-series Cutters User’ s Manual
Operation 2-24
However, in case your cut resembles the pattern illustrated above, increase the
value displayed on the LCD by pressing the jogging key to correct closing
of the lines cut.
To repeat the test, press the key.
A complementary test has been added to fine tune the LAT. adjustment.
Press the 2 key to perform the vertical test shown above. All the squares should
be identical.
Press the key to go to the next step of the procedure.
2.5.1.3. ADJUST LONG. test routine
ADJUST LONG
↑↓ 0 1
Press to execute the LONG test.
The test pattern is similar to the LAT-test.
Check the quality of the cuts: the end of the vertical cuts should coincide
precisely with the horizontal cuts, without any gaps.
Weed out the rectangle and if you obtained a pattern as illustrated above,
decrease the value displayed on the LCD by pressing the jogging key to
correct closing of the lines cut.
To Next Page
Loading...
