18
NOTE: Pressing the POWER key once can switch off the audible alarm when the alarm is on.
Up
Used to increase (warm) the set temperature by 1°C/1ºF.
To switch on the Silent mode, press and hold the UP key for 5 seconds. Three beeps will confirm the
selection.
Down
Used to decrease (cool) the set temperature by 1°C/1ºF.
To switch on the Dynamic Cooling mode, press and hold the DOWN key for about 5 seconds. Five
beeps will confirm the selection.
Light
The interior light makes it easy to view your items. Pressing the LIGHT symbol toggles between 2
modes of operation for the internal lights: functional (default) mode and showcase mode. If you are
in functional (default) mode, the lights will turn on only when the door is open. If you are in showcase
mode, the lights will be on whether or not the door is open.
ºF/ºC Selector
Select the temperature display in Fahrenheit or Celsius degrees. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold the LIGHT key for 5 seconds.
Setting the Temperature Control
• You can set the temperature by pressing the UP and DOWN symbols. When you press either of
the two buttons for the first time, the LED readout will show the original temperature set
previously. (The temperature preset at the factory is 38°F (3°C).
• The temperature you are setting will increase by one degree each time you press the UP symbol
and will decrease by one degree each time you press the DOWN symbol.
• The range of the temperature control is from 36°F to 43°F.
• To view the set temperature at any time, press the UP or DOWN symbol. The set temperature will
flash in the display window for 5 seconds. After 5 seconds, the temperature inside the unit will
reappear in the display window.
NOTES:
• If the unit is unplugged, or power is lost or turned off, you must wait for 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
• When you use the unit for the first time or restart the unit after it has been shut off for a long time,
there could be a few degrees variance between the temperature you select and the one
indicated on the LED readout. This is normal and is due to the length of the activation time.
There should not be a problem once the unit has been running for a few hours.
Dynamic Cooling Mode
When your appliance is first turned on, it operates in Dynamic Cooling mode. If the interior
temperature of the unit must be the same throughout the storage cabinet, you should switch to
Dynamic Cooling mode. This causes the interior fan to circulate the inside air evenly, even after the
set temperature is reached.
To Next Page
Loading...
