“E3” or “E4” indicates that the defrost
sensor in the evaporator has failed.
“E5” indicates a defrost heater failure.
“E6” indicates a solenoid valve failure.
“E7” indicates a door switch failure.
The alarm
sounds and
the
temperature
display
flashes.
Has the appliance door been open for
longer than 60 seconds? If not, then the
temperature has risen higher or fallen
lower than the set temperature. This
could be due to:
The appliance door has been opened too
often.
The ventilation opening is covered or too
dusty.
A lengthy interruption to the power
supply.
A large number of items have been
added to the unit.
If yes, close the door.
Do not open the door more often than
necessary.
Clear the obstructions and clean off the
dust.
Let the appliance work for a while until
the set temperature has been
reached.
The icon “--”
is lit up and
flashing in the
temperature
display.
The displayed temperature is out of
range.
Only temperatures within the range
0~99°F/-9~37°C can be displayed. If
the temperature is not within this
range, the icon “--” will be displayed
instead. This is normal.
If you have checked the table above and find that you still need help with your appliance, call our
Customer Service facility at 800-932-4267 between 9:00 AM and 5:00 PM ET. We will do our best
to answer your questions.
CALIFORNIA CARB/SNAP DISCLOSURE
This product uses eco-friendly hydrocarbon refrigerant and fully complies with California
CARB regulations.
However, we are required by California Law to provide the following disclosure statement in every
product sold in California.
"This equipment is prohibited from use in California with any refrigerants on the 'List of Prohibited
Substances' for that specific end-use, in accordance with California Code of Regulations, title 17,
section 95374. This disclosure statement has been reviewed and approved by Felix Storch, Inc. and
Felix Storch, Inc. attests, under penalty of perjury, that these statements are true and accurate."
This product does not use any refrigerants on the 'List of Prohibited Substances'"
To Next Page
Loading...
