16
CLEANING AND CARE
Exterior
The outside surface is pre-coated steel and plastic. Clean the outside with mild soap and water, and
then rinse and dry with a soft cloth. Do not use any type of household or abrasive cleaner.
Door
Wipe the door window on both sides with a damp cloth to remove any spills or spatters. Metal parts
will be easier to maintain if wiped frequently with a damp cloth. Avoid the use of sprays and other
harsh cleaners as they may stain, streak, or dull the door surface.
Control Panel
Carefully clean the control panel immediately after it is soiled. If the control panel becomes soiled:
1. Open the oven door before cleaning.
2. Wipe the panel with a cloth dampened slightly with water only.
3. Dry with a soft cloth.
NOTE: Do not scrub or use any sort of chemical cleaners. Close door and press STOP/CANCEL.
Interior
Wipe the interior surfaces with a soft cloth and warm water. DO NOT USE AN ABRASIVE OR
HARSH CLEANER OR SCOURING PAD. For heavier food spatter, use baking soda or a mild soap,
and rinse thoroughly with hot water.
Waveguide Cover
• The waveguide cover is on the right side of the cavity. It is made from Mica and requires special
care to ensure good, even performance.
• Remove any food spatters immediately by wiping with a damp cloth. Built-up splashes may
overheat and cause smoke or possibly catch fire. DO NOT REMOVE THE WAVEGUIDE
COVER.
Odor Removal
Occasionally, a cooking odor may remain in the oven. To remove, combine 1 cup water, grated peel
and juice of 1 lemon and several whole cloves in a 2-cup glass measuring cup. Boil for several
minutes using 100% power. Allow to set in oven until cool. Wipe interior with a soft cloth.
Turntable/Turntable Support
The turntable and turntable support can be removed for easy cleaning. Wash them in mild, soapy
water, and the dry thoroughly. For stubborn stains, use a mild cleanser and a non-abrasive scouring
sponge, and wash in mild, soapy water before drying.
The turntable and support are also dishwasher safe. Use upper rack of dishwasher. The turntable
motor shaft is not sealed, so excess water or spills should be wiped up immediately.
To Next Page
Loading...
