Summit SEW24SS - Page 17

Consumer SupportTroubleshooting TipsCare and CleaningOperating InstructionsSafety Instructions
17
How to Setthe Oven for Convection Roasting When Using the Probe
The display will flash PROBE and the oven
control will signal if the probe is inserted
into the outlet, and you have not set a probe
temperature and touched the Start pad.
To prevent burns, do not unplug the probe from
the oven outlet until the oven has cooled. Do not
store the probe in the oven.
For best results when roasting large
turkeys and roasts, we recommend
using the probe included in the
convection oven.
When the internal temperature of the
food reaches the number you have set,
the probe and the oven turn off and the
oven control signals. To stop the signal,
touch the Clear/Off pad. Use hot pads to
remove the probe from the food. Do not
use tongs to pull on it-they might
damage it.
When the oven starts to heat, the word LO
will be in the display.
After the internal temperature of the food
reaches 100°F, the changing internal
temperature will be shown in the display.
1
2
3
4
5
6
7
8
Touch the Start pad.
To change the oven temperature during the
Convection Roast cycle, touch the
Convection Roast pad and then touch the
number pads to set the new desired
temperature.
Place the rack in the rack position (A).
Insert the probe completely into the
food.
Plug the probe into the outlet in the
oven. Make sure it is pushed all the way
in. Close the oven doo r.
Touch the Convection Roast pad.
Touch the number pads to set the desired
oven temperature.
Touch the Probe pad.
Touch the number pads to set the desired
internal food temperature.
NOTE
:
If the probe is removed from the food before
the finel temperature is reached, a tone will
sound and the display will flash until the
probe is removed from the oven.
You will hear a fan while cooking with this
feature. The fan will stop when the door is
opened but the heat will not turn off.
You can use the timer even though you
cannot use timed oven operations while
using the probe.
Probe is not for use in Broil functions.
Do not use probe when cooking in rack level D.