8
Using the clock and timer.
To Set the Clock
To Cancel the Timer
Touch the TIMER pad twice.
To Set the Timer
Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
The clock must be set to the correct time of
day for the automatic oven timing functions
to work properly. The time of day cannot be
changed during a timed baking or cleaning
cycle.
Make sure the clock is set to the correct
time of day.
1
2
3
The Timer is a minute timer only.
The Timer does not control oven
operations. The maximum setting on
the Timer is 9 hours and 59 minutes.
Touch the TIMER pad.
Touch the number pads until the amount
of time you want shows in the display.
For example, to set 2 hours and 45
minutes, touch 2, 4 and 5 in that order. If
you make a mistake, touch the TIMER
pad and begin again.
Touch the START pad.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a Timed
Cycle.
When the Timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the TIMER pad is
touched.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
1
2
3
4
Consumer Support
Troubleshooting Tips Care and Cleaning Operating Instructions
Safety Instructions
To Next Page
Loading...