Sun Chiro Table Prestige - Page 2

2
WARRANTY:
• All Standard Line Tables carry a one-year warranty on materials and workmanship (upholstery is warranted for workmanship
only).
• Presge Line and Contemporary Tables carry a two-year warranty on materials and workmanship (upholstery is warranted for
workmanship only).
• Elevaon columns installed on Contemporary tables are warranted for one year by the manufacturer of the provided columns.
• As a courtesy service we will ship replacement parts to you at no expense, however you will be responsible for the installaon
of the provided parts. The excepon to this service is tables which have been shipped outside the Connental US. In such
situaons the customer will be responsible to cover applicable shipping costs less an equivalent Domesc shipping allowance.
At Sun Chiropracc Tables, LLC sole discreon “hard parts” (dened as those mechanical table parts subject to wear and breakage)
may be provided to the original customer at no charge except for the cost of shipping, at any me both before and aer the
terminaon of the warranty periods stated above.
10 DAY RETURN POLICY:
We oer a 10 day, no-quesons asked return policy for all the standard tables we oer. Please note that this policy does NOT
include tables with custom colors or other customized opons. Tables with a custom color or other custom opons may not be
returned for any reason.
If not sased with your table for any reason you may return it at your expense for a complete refund excluding original shipping
paid. You must contact us within 10 days of arrival to let us know that you will be returning the table. This allows you 10 full days to
decide if you are happy with your purchase.
Returns will not be accepted if you fail to contact us within 10 days of the table's delivery. Tables must be returned in "new"
condion. Tables not returned in "new" condion will have their refund decreased by the stated cost of noted damage.
For the most updated warranty and return policy informaon, please see our website at sunchirotable.com.
TABLE LEVELING AND MAINTAINANCE:
Table Leveling:
To level your table, place it in the approximate posion where it will be used. The bolt holes on the legs are oversized to
accommodate approximately 1/8” of leveling and ease assembly.
When the table is in posion, loosen the 12 leg bolts to just snug. DO NOT loosen them to the point where the washers will spin.
Place your hands on the table and “wiggle” it a bit so it can sele to the shape of your ooring. When sased, and without
moving the table, from the underside ghten the bolts to snug. DO NOT over ghten. The bolt is fully ghtened when the cut lock
washer is fully compressed and at.
Leg Maintenance:
As paents are treated the table will sele over me. This can cause the leg bolts to require ghtening. We suggest that you
ghten the leg bolts once aer about 2 weeks of use and again at about 3 months. You can then check the bolts about once every
6 months for maximum safety.
If at any me the table legs seem or appear loose, please ghten them. DO NOT wait for a scheduled maintenance period. It is a
good idea for liability purposes to keep a log of when you maintain all of your equipment.
General Maintenance:
To keep your tables in opmal condion, don’t forget to do roune table maintenance and keep a record of your inspecons. You
will nd a printable maintenance log on our website under the Customer Support > Table Documentaon tab. In the boom le
hand corner of the log there is a quick list of what should be done during the periodic inspecons. We suggest that your tables be
inspected and lubricated every 90 to 120 days for opmal performance.