5
Hardware Bag:
All Tables:
1. 12 Leg bolts (10 Classic Tables) consisting of 3 inch 5/16 Hex Bolts a lock washer, and a fender
washer.
2. 5 triangle bolts consisting of 3 long hex head lag screws with 1 flat washer.
3. A medium sized hair pin for the T-Bar.
4. 2 hinge pins to attach headpiece (Exception elevation headpiece equipped tables).
Elevation Headpiece Equipped Tables
1. 4 Lag screws 1 1/2 inches long and 4 flat washers in marked bag
Handle Cocking Drop Tables
1. The appropriate number of cocking handles
2. Appropriate number of tension knobs.
3. 8 #8 machine screws per cocking rod.
4. 2 cover plates per cocking rod.
Kick Drop Equipped Tables
1. The appropriate number of kick drop pedals
2. Appropriate number of tension knobs
3. 5/8 nut and lock washer for tightening the kick down rod (shipped on the rod).
Lumbar Prop and Drop Equipped Tables (marked bag)
1. Hairpin
2. Screw on handle
Arm Rests
Bag containing four 3 1/2 inch 5/16 bolts, 4 flat washers, 4 fender washers and four lock nuts.
Assembly: Step 1: Attaching the Front Triangle
This step requires the 5 triangle attachment lag
screws. These are 2 1/2 inches long and 1/4 sized.
They will be found in the hardware bag along with 5
flat washers. You will need a 7/16 socket and
wrench to easily install them.
To Next Page
Loading...