7
Place each leg in its proper position on the
frame. The letter on the leg is placed over the
corresponding letter on the frame.
Each leg is attached using three 3" Bolts w/
split lock washer and fender washer. The
bolts are tightened with a 1/2" socket wrench.
Do NOT over tighten the leg bolts. The bolts
are fully tightened when the split lock washer
is compressed and flat.
Now, with the assistance of a helper, turn
the table upright onto its legs. You may
need to level the adjusting table at this point.
To do this, loosen all twelve leg bolts slightly
then wiggle the table a bit until it settles into
the shape of your floor. When satisfied tight-
en the leg bolts again just to snug. Do NOT
over tighten the leg bolts. The bolts are fully
tightened when the split lock washer is flat.
To Next Page
Loading...