Sun Microsystems MCS 2000 SL - Page 62

2
3.
Ensure that the
readings
are stable
and
press
the
*
key.
4. Connect or
turn on the
equipment
mentioned in
step
2.
LOW SPEED SECONDARY
KV
TEST
Enter
the
"LOW
SPEED SECONDARY
KV TEST" from
the
"WORKSHOP
TEST SELECTION"
menu
or
enter
it from
the
previous
test.
Bring
the
engine
RPM w'ithin
the
specified RPM
(this
js
between
the
arrows
> <
which
are
shown
in the
graph
on top
of
the
screen)
and
press
the
*
key.
HIGH
SPEED SECONDARY
KV TEST
Enter the
"HIGH
SPEED SECONDARY
KV
TEST"
from the
"WORKSHOP
TEST
SELECTION'r
menu
or
enter it from the
previous
test.
Bring the
engine
RPM within the
specified
RPM
(this
is
between
the
arrows
> <
which
are shown
in the
graph
on
top
of the screen) and
press
the
*
key.
SNAP
ACCELERATION
TEST
Enter the
"SNAP
ACCELERATION TEST" from the
"WORKSHOP
TEST
SELECTION"
menu
or
enter
it from
the
previous
test.
Bring the
eng'ine
RPM within
the
specified
RPM
(this
is
between
the
arrows
> <
which
are
shown
in
the
graph
on
top
of the screen) and
press
the
*
key.
Snap accelerate by depressing and immediately releasing the throttle
pedal.
Note: You
should use
the throttle
pedal
rather than the
under
bonnet
linkage.
This
ensures
that
any engine management system fitted
will
react to
the throttle
movement.
The
action shou'ld consist of
a
firm
and
positive
movement
using one
foot, in
the exact same
way
as one
would
accelerate
when
overtaking.
1
2
2
3
Page
56
1
1