Sunbeam 9362 - Page 8

Assembly
Page 8
To continue assembly refer to page 12.
Natural Gas Conversion
Natural gas conversion must be performed only by a natural
gas provider or service company.
Refer to pages 9 - 11 for more information.
High Altitude Conversion
For installations above 2,000 feet, contact your local dealer or gas supplier
before installing as input ratings will be reduced approximately 4% for each
1,000 feet above sea level. Refer to the National Fuel Gas Code.
*High Altitude Conversion Kit
Contact your distributor to obtain a High Altitude Conversion Kit.
conversion label.
Refer to pages 9 - 11 for more information.
5. Attach the Bottom Plate (F) to Left Side Panel (C), and Right Side Panel (J).
DO NOT OVERTIGHTEN as you will need to adjust the holesto ensure proper
alignment.
BB M6x25 Bolt x4 CC M6 Washer x4
6. Attach the Cross Bar (D) to Bottom Plate (F) and Back Panel (B)
AA M6x10 Bolt x2 CC M6 Washer x2
5 6
BB
CC
C
J
F
AA
AA
CC
CC
F
B