Sunbeam Belle-Aqua - Sunbeam’s 3-Way Safety System; Care and Cleaning

Sunbeam’s 3-Way Safety System
Safety is a major consideration in the design of a Sunbeam kettle. This is why we have developed our 3-Way Safety
System, which ensures that your kettle will:
1. Automatically switch off after boiling.
For convenience, safety and energy efficiency, your Sunbeam kettle features an auto cut-out device.
2. Cut-out for boil-dry protection.
If the kettle is operated without water, it will automatically cut-out, preventing any damage to the element.
3. Shut-down in case of overheating.
In the event of overheating, the kettle will automatically shut down to prevent further damage. Should this occur,
take your kettle to a Sunbeam Service Centre or Appointed Service Agent.
Care and Cleaning
Always disconnect the kettle from the power outlet before cleaning.
Never immerse the kettle switch area, cord or power base in water, or allow moisture to come into contact with these
parts.
Removal of mineral deposits.
Mineral deposits in tap water may cause the interior of the water gauge to discolour.
To remove this build-up, use Sunbeam Liquid Descaler, a simple to use, non-toxic cleaner available from Sunbeam
Appointed Service Agents.
Alternatively:
1. Fill the kettle with 3 cups of white vinegar and the remainder with water and allow to stand overnight. DO NOT
BOIL.
2. Empty the solution from the kettle. Fill the kettle with clean water, bring to boil and then discard the water.
Repeat and the kettle will then be ready to use.
To clean the stainless exterior.
The stainless steel surface may be wiped over with a damp cloth and polished with a soft dry cloth.
CAUTION: Do not use chemical, steel wool, or abrasive cleaners to clean the outside of the kettle, as these will
scratch the stainless steel surface.