IRONING PANTS
• Begin with the waistband and inseam area, then pockets and cuffs.
• Pull waistband on pointy end of the board, as if you’re “dressing” the ironing
board. Iron upper-front part of the pants, including the waistband.
• Place pants parallel to ironing board lengthwise so both legs are facing the same
direction. Iron each leg by moving the iron back and forth along the pant leg.
• Take cuff of the leg and bring it over towards the waistband to iron the inner part
of the leg. Repeat these 2 steps for the second leg.
-E14- -E15-
PROBLEM CAUSE/SOLUTION
Red Indicator Light is
blinking
• The light blinks to indicate that the iron auto-off
function has been activated.
• To stop the blinking and reset, move the iron back
and forth and allow to reheat.
Iron is not heating • Check that unit is plugged into the Heating Base and
that the electrical cord is plugged into a working
electrical outlet.
• Adjust Fabric Select Dial to the correct setting for
your garment.
• Verify the auto-off function is not active. Refer to
MOTION SMART
®
3-WAY AUTO-OFF FEATURE
section for details.
Iron will not steam • Ensure water tank level is at least ¼ full.
• Ensure steam lever is set to a steam setting.
• Press SHOT OF STEAM
®
button several times to
prime.
Iron is leaking • Only fill with water to the Max level.
• SHOT OF STEAM
®
button has been pressed too
frequently. Only use in 3-second intervals or less.
• Empty de water reservoir after each use and move
Steam Lever to the Dry setting.
TROUBLESHOOTING
TROUBLESHOOTING CONT.
PROBLEM CAUSE/SOLUTION
Iron leaves spots/
flakes on clothing
• Empty water reservoir completely after each use.
• Clean soleplate when cool with a wet, damp cloth.
• Use self-cleaning feature once a month.
• Refer to the Anti-Calcium System section.
• Ensure water cup used to fill the iron is clean.
Wrinkles are not sufficiently
removed
• Use SHOT OF STEAM
®
or SPRAY MIST
®
features to
help remove stubborn wrinkles.
• Check that the Fabric Select Dial is set to the correct
fabric setting
• Refer to Ironing Tips or visit www.sunbeam.com for
more tips and hints.
Fabrics are getting an
unwanted “shine”
• Use an ironing cloth or a 100% white cotton fabric
and place it between the garment being ironed and
the iron to prevent “shine.”
IRONING TIPS CONT.
To Next Page
Loading...
Need help?
General