4
Always disconnect the kettle from the power
outlet before cleaning.
Never immerse the kettle switch area, cord or
power base in water, or allow moisture to
come into contact with these parts.
Descale Your Kettle Regularly.
Mineral deposits in tap water solidify when
the water is heated; lime scale may be white,
coloured, even rusty-looking and is normally
visible. Phosphate scale isn't generally visible
however it may cause the water to appear
cloudy when heated. This may cause the
interior of the water gauge to discolour, cause
overheating, trigger the boil-dry cut-out
mechanism or even reduce the kettle’s life.
Even in soft water areas it is important to
descale your kettle regularly to help maintain
its lifecycle.
NOTE: Failure to descale products regularly
can be deemed as negligent handling and
any faults caused by mineral build up will
not be covered by the Sunbeam 12 Month
Guarantee.
To remove this build-up, use Sunbeam Liquid
Descaler, a simple to use, non-toxic cleaner
available from Sunbeam Appointed Service
Agents.
Alternatively:
1. Fill the kettle with 1 cup of white vinegar
and the remainder with water and allow to
stand overnight. DO NOT BOIL.
2. Empty the solution from the kettle. Any
stains remaining inside the spout can be
removed by rubbing with a damp cloth. Fill
the kettle with clean water, bring to boil
and then discard the water. Repeat and the
kettle will then be ready to use.
Cleaning the concealed heating element
This kettle features a non-corrosive stainless
steel heating element. Over time, scale may
build up on the concealed element inside the
kettle, causing discolouration that may have
the appearance of rust. Be assured this is not
rust. If this occurs clean with a green
Scotchbrite
®
scourer or similar and a suitable
abrasive cleaning cream. Rinse and clean
thoroughly with tap water before using your
kettle again.
CAUTION: To prevent damage to the
appliance, do not use alkaline, chemical ,
steelwool or abrasive cleaners. Use a soft
cloth and a mild detergent to protect the
exterior surface.
To clean the mesh filter.
Grasp the top of the mesh filter and pull
upwards to remove. Wash in warm soapy
water and dry thoroughly before replacing
in the kettle.
Care and Cleaning
KE6310_16EM1.indd 4 9/12/16 9:42 AM
To Next Page
Loading...
