Sunbeam T9 User Manual

Supersedes Service
Bulletin No. 2~"
Revls~d April 8, 19~I
No, 17-2 TOASTER
January 3, 19~9
¯ XNSTRUGTIONS FOR,, SE~VZGI~G SUNBEAM SILENT
AUTOMATXG, TOASTER MODEL T~_
GENF~RAL
The Model
~
T9 Sunbeam Silent Automatic Toaster differs from pwevioUs Sunbeam
toasters in design and in the addition of a selective "po.~-up" feature by
which the toast may be made either to rise automatically or to remain inside
the~toaster at the end of the toas$ing period by the setting of a control
knob. The thermostat timing mec~mnism is so arranged that it will toast
bre .ad..~.t,.o .the same reasonably uniform degree of brownness whether the toaster
is hot or cold. No toaster, however, will automatlc’~lly and effectively
compensate for voltage fluctuations or for considerable differences in
bread (as between whole wheat and white bread, or fresh and dry bread),
but such variations can be taken care of by a change in thin set.ring of .the
Bakelite adjustment knob on the side of the Sunbeam Toaster. For large
voltage variations a second adjustment can be made readily as described in-
the Toaster instruction booklet, (one of these booklets is attached to next
page) and as explained in Section 3N-3 of this bulletin.
The thermomtat is located
at
one eau of the toasting chamber and.the "pop-up"
mechanism at the other. The hinged crumb-plate under the toasting chamber~.~.~... -
easily opened for cleaning, The wiring diagram on the next page shows the?...~.i~:~:i~i!~,.

Sunbeam T9 Specifications

General

Slots	2
Browning Control	Yes
Cancel Function	Yes
Crumb Tray	Yes
Power	900W
Extra Wide Slots	Yes
High Lift Lever	Yes
Defrost Function	Yes
Reheat Function	Yes

Summary

Sunbeam Corporation Service Bulletin

General Overview of Model T9 Toaster

Introduces the Model T9, its selective "pop-up" feature, and thermostat timing mechanism for consistent toasting.

How to Service Model T9 Sunbeam Automatic Toaster

Normal Operation Procedures

Explains the toaster's normal functioning, heating elements, and thermostat cycle for proper operation.

Initial Disassembly Steps

Details removing the bottom cover, thermostat bracket, and thermostat blade for servicing the toaster.

Disassembly of Base, Body, and Rack

Component Removal and Preparation for Assembly

Details removal of signal light, mounting plate, reflector, elements, and piston for reassembly.

Assembling Model T9 Toaster

Installing Toasting Elements

Guides on fitting toasting elements, ensuring correct grade numbers and electrical connections for optimal performance.

Internal Assembly Procedures

Steps for fitting the element frame top, guide wires, mounting plate, reflector, and shaft assemblies during reassembly.

Assembly of Springs, Levers, and Rods

Details fitting switch/ejector springs, switch locking lever, and cut-out rod during the assembly process.

Final Assembly Checks and Thermostat Adjustment

Covers checking pop-up mechanism, body sections, base attachment, and initial thermostat setup.

Thermostat Calibration and Toasting Adjustment

Using weights to calibrate thermostats for precise toasting and final adjustments for consistent results.

Repairs and Troubleshooting

Testing Electrical Connections

Explains how to test heating elements and cord for continuity using a tester to diagnose heating failures.

Troubleshooting Non-Heating Issues

Guides on diagnosing and resolving issues other than heating elements, referencing specific sections for guidance.