Sunbeam warming - Remote Control Operation; Single Control Setup; Dual Control Setup; Installing Remote Batteries

4
DUAL CONTROL SET UP
run cord
under the bed
Base Unit
(under the bed)
Cord
Connector
Module
Label
Power Cord
Flag
Tag
Head of the bed
Foot of the bed
run cord
under the bed
Base Unit
(under the bed)
Cord
Connector
Module
Label
Power
Cord
Flag
Tag
Head of the bed
Foot of the bed
1
2
3
4
5
6
1
2
3
4
5
6
5
SINGLE CONTROL SET UP
Features:
• REMOTE CONTROL – cordless operation
• AUTO-OFF – 10 hour independent auto-off (see page 2)
• ELECTRONIC DIGITAL CONTROL – for easy setting with backlit LCD
• PRE-HEAT – for cozy warmth before bedtime (see page 2)
• 10 TEMPERATURE SETTINGS – select your personal comfort level
• SOLID STATE – for accurate and consistent heat control
• EASY GRIP – ergonomic control for easy operation
• AUDIBLE BEEP – indicates setting change
I85R (Single Control)
I85RKQ (Dual Control)
Remote
1
2
3
Installing the Batteries:
1 Remove the battery compartment door from the back
of the remote control.
2 Insert three AAA batteries, matching the + and -
markings in the battery compartment to the markings
on the batteries.
3 Replace the battery compartment door.
4 If your pillow top mattress pad has two remote
controls, repeat steps 1 – 3 to install batteries in the
second remote control.
(Three AAA batteries per control not included)