Suncast BMS6583 - Header Pre-Assembly; Install Beams and Adapters on Front Header; Install Beam and Bracket on Rear Header

Header Pre- Assembly
Place Front Header ( K) face down on flat surface. Place one header beam ( Y) in each channel above and below the
window openings. Secure Beams ( Y) with two screws ( NN) each. Place short side adapter ( CC) between windows
with the flat bottom end facing down. Secure adapter ( CC) with four screws ( NN).
Place Rear Header ( L) face down on flat surface. Place remaining header beam ( Y) in channel on back of header.
Secure Beam ( Y) with two screws ( NN). Place support bracket ( Z) at center of beam with the flat bottom end facing
down. Secure bracket ( Z) with two screws ( NN).
14