Need help?Do you have a question about the Suncast BMS6583 and is the answer not in the manual?
Crucial information on unpacking, laying out parts, and verifying completeness before assembly.
Essential safety guidelines for shed assembly and use, covering site prep, weather, and handling.
Attaching the D-ring slide bolt to the top interior of the left door using screws.
Attaching the D-ring slide bolt to the bottom interior of the left door using screws.
Preparing the front header by adding gaskets and securing window panes with screws.
Assembling the left side header with a gasket and securing the side window pane.
Installing header beams and side adapters onto the front header using screws.
Installing a header beam and support bracket onto the rear header using screws.
Joining the front and rear floor panels together and securing them with screws.
Aligning and attaching the left front corner panel to the front floor.
Adjusting the left front corner panel by tipping it outward and bending the hinge.
Returning the left front corner panel to vertical and aligning its lower tabs with floor slots.
Verifying the corner squareness and panel flushness with the floor, repeating previous steps if necessary.
Aligning and attaching a side panel to the floors by sliding it into place.
Fastening the side panel using easy bolts and the provided driver, ensuring proper seating.
Repeating previous wall attachment steps for the remaining corner and back panels.
Placing and securing the front header over the door opening using screws.
Placing and securing the rear header onto the back wall using screws.
Attaching the side headers to the front and rear headers, securing with screws.
Attaching side adapters to the right side and back corners of the shed interior using screws.
Securing wall adapters to the side walls of the shed interior with screws.
Placing the ridge beam onto side adapters and securing it with bolts and nuts.
Attaching support brackets to the front of the ridge beam using screws.
Mounting truss legs onto adapters, brackets, and headers, securing with bolts and nuts.
Aligning and attaching the first roof panel to the right side header.
Aligning and attaching the second roof panel to the left side header.
Fastening the roof panels to the front header using screws.
Fastening the roof panels to the back header using screws.
Fastening each truss leg to the roof panels using screws.
Mounting metal hinge plates onto the right door's hinge mounts.
Sliding the right door's hinges onto the shed's receptacle points.
Securing the metal hinge plates to the shed with screws and locking nuts.
Installing the right door latch plate with screws, washers, and locking nuts.
Installing the left door latch plate with screws, washers, and locking nuts.
Attaching door handles to the doors by inserting stems and securing with washers and screws.
Engaging and locking the D-rings on the door latch and securing with an external lock.
To Next Page
General