14
Lay front header (J) on ground with lettering side facing
up. Place berglass vent screen (Y) into rear opening in
front header (J). Secure with eight screws (JJ). DO NOT
over tighten screws.
Place header beam (Z) into pocket of front
header (J). Secure with six screws (JJ). DO NOT over
tighten screws.
Header Pre-Assembly
Slide roof ridge beam bracket (X) under tabs on
inside peak of front header (J) and secure with two
screws (JJ). DO NOT over tighten screws.
Repeat Steps 5-7 for rear header (K)
To Next Page
Loading...
