Suncast Tremont - Page 17

Shed Assembly/Walls ( continued)
Align tabs on bottom of back panel ( H) with slots along
floor ( V) & ( W). Lower panel into slots and lock in place
by sliding panel toward rear corner.
7
Note: Use a rubber mallet to " push" back
panel ( h) into locked position.
Secure back panel ( H) with four easy bolts ( T), working
from floor to roof. DO NOT use torque wrench. Use easy
bolt easy driver ( U) and hand tighten. Easy bolt head will
be flush when fully seated. DO NOT over tighten easy
bolts.
Note: You may hear a click when easy bolt has been
tightened completely.
17