Suncast Tremont - Page 19

Shed Assembly/Headers
Place rear header ( K) over back walls and fit four
protruding support legs into pockets molded in back
walls. Secure rear header using eight screws ( X).
Place front header ( J) over door opening and fit four
protruding support legs into pockets molded in front
corners. Secure front header using two screws ( X).
Raise ridge beam ( P) up and into rear header ( K) Secure
with one bolt ( HH) and one nut ( JJ). DO NOT tighten.
Repeat for front header ( J).
Note: Header panels may need to be pushed inwards or
outwards slightly as ridge beam is slid into place.
19