Why is there no heat in my Sundance Spas Bristol?
If your Sundance Spas Hot Tub isn't heating, start by checking the thermostat setting. Ensure the hot tub cover is in place while heating. Also, verify the settings to see if your hot tub is in economy mode.
How to reduce the water temperature in my Sundance Spas Hot Tub?
If the water in your Sundance Spas Hot Tub is too hot, reduce the thermostat setting.
How to fix a pump that does not operate on my Sundance Spas Bristol?
If the pump on your Sundance Spas Hot Tub isn't working, first press the JETS 1 button. Ensure power is going to the hot tub and verify the water level. Also, check that all jets are in the open position. The pump may need priming, especially after draining and refilling. Press the JETS 1 button several times for 5-10 seconds each time. Finally, turn the power off and release air from the plumbing by removing the filter cartridge. Reinstall the filter before turning the power back on.
How to improve poor jet action in my Sundance Spas Bristol?
To improve poor jet action in your Sundance Spas Hot Tub, ensure all jets are fully open. Press the JETS 1 button to activate pump #1. Confirm all air controls are in the 'on' position. Also, check the filter for dirt and clean it if necessary.
What to do if none of the components operate on my Sundance Spas Bristol Hot Tub?
If none of the components are working on your Sundance Spas Hot Tub, check if there is power to the hot tub and see if the household circuit breaker has tripped.
What to do if my Sundance Spas Bristol displays FL--1 or FL--2 error?
If you see 'FL--1' or 'FL--2' on your Sundance Spas Hot Tub display, immediately turn the power off. Verify the water level is above all jets but below the lowest pillow; add water if needed. Check for a clogged or dirty filter cartridge. To purge an air lock, remove the filter cartridge and use a garden hose over the filter cartridge wall fitting with a rag seal while a helper turns on the water for 30 seconds, then off. Reinstall the filter cartridge and check the hot tub. If the circulation pump isn't running, turn the power off at the main breaker, then back on.
Crucial safety precautions and warnings for spa operation, covering entrapment and electrical hazards.
Understanding and preventing entrapment hazards related to suction fittings and moving parts.
Information on hyperthermia, its causes, symptoms, and risks associated with excessive water temperatures.
Essential guidelines for safe electrical installation, grounding, and operation of the spa.
Specifications for electrical power requirements for different spa models and configurations.
Detailed instructions for the proper and safe electrical wiring of the spa system.
Information and maintenance for the CLEARRAY UV purification system, including bulb replacement.
Understanding error messages like COOL, ICE, SN-1, SN-2, and OH for diagnostics.
Troubleshooting errors related to flow switch malfunctions and filter issues (FL-1, FL-2, FL-3).
Step-by-step procedures to resolve common operational issues like pump, jet, and heating problems.
General| Seating Capacity | 5-6 adults |
|---|---|
| Shell Type | Acrylic |
| Cabinet | Synthetic |
| Lighting | LED Lighting |
| Insulation | Full-Foam Insulation |
| Pump(s) | 2 pumps |
| Filtration | MicroClean filtration system |
| Water Care | ClearRay UV-C water sanitizer |
To Next Page