What to do if Sundance Spas Marin 880 Hot Tub water is too hot?
If the water in your Sundance Spas hot tub is too hot, do not enter the water. Remove the hot tub cover to speed up the cooling process. You can also reduce the thermostat setting or switch the hot tub to "Economy" mode to only heat during programmed filter cycles.
Why is my Sundance Spas Marin 880 not heating?
If your Sundance Spas hot tub isn't heating, check the thermostat setting and ensure the cover is in place while heating. If the "heater on" indicator is lit but the temperature doesn't rise after a while, contact a qualified service technician.
What to do if my Sundance Spas Marin 880 Hot Tub pump does not operate?
If the pump in your Sundance Spas hot tub doesn't operate, depress the JETS button. If you don't hear any sound or if there's a buzzing sound, turn off the power to the spa and contact a qualified service technician.
What to do if my Sundance Spas Marin 880 filter/circulation pump is off?
If the filter/circulation pump cycle on your Sundance Spas hot tub was canceled due to a power interruption, wait 24 hours for the hot tub to reset. Alternatively, you can manually activate it by pressing the select button.
What to do if my Sundance Spas Hot Tub components don't operate?
If none of the components in your Sundance Spas hot tub are operating (pump, blower, light, etc.), check the household circuit breaker.
What to do if Sundance Spas Hot Tub has proper water flow inhibited?
If the proper water flow is inhibited in your Sundance Spas hot tub, check for the correct water level and inspect for a clogged filter.
What to do if Sundance Spas Marin 880 has power fluctuation?
If a power fluctuation in the secondary power line is causing the DC voltage to be low in your Sundance Spas hot tub, try resetting power to the spa. If the power level returns to normal, the PF error will reset itself.
Guidance on selecting an optimal outdoor location for the hot tub.
Factors to consider for indoor hot tub installation.
Customizing massage with selectors and adjusting specific jets.
Instructions for adjusting specific jet types for massage impact.
Setting filter/circulation pump start time and duration.
Adjusting heat cycles in economy mode.
Step-by-step guide for replacing the MicroClean Plus filter cartridge.
Procedure for draining and refilling the hot tub water.
Maintaining the cover, winterizing, and restarting in cold weather.
Maintaining proper pH and sanitizing the water.
Troubleshooting steps for components not operating or pumps.
Troubleshooting poor jet action, high temp, and no heat problems.
General| Seating Capacity | 5-6 adults |
|---|---|
| Heater | 5.5 kW |
| Diverter Valves | 2 |
| Shell Material | Acrylic |
| Lighting | LED |
| Control System | i-Touch |
| Cabinet Material | Synthetic |
To Next Page