1. Filter
2020-06-04
OI01H-2021 SR 100 4
1.1 Check that you have
selected the correct filter.
1.2 During work in
atmospheres containing both
particulates and gases/vapors
(such as spray painting) the
particulate filter and chemical
cartridge should be
combined.
1.3 Place the P100
particulate filter on top of the
cartridge. Grasp both
protective elements. Squeeze
hard until you hear the P100
snap onto the cartridge a
snap. Attempt to pull the filter
and cartridge apart to check
that they are properly
connected.
1.4 Place a coin it in the
space between the lower lip
of the particulate filter and the
small tab moulded into the
side of the cartridge.
Push firmly and twist the coin
until the filter pops off.
To Next Page
Loading...
Need help?
General
