1. Filter
2020-03-06
OI01H-2018 SR 100 4
1.1 In environments in which
both gases and particles
occur, such as in spray
painting, gas and particle
filters must be combined.
1.2 Place the particle filter on
top of the cartridge. Grasp
both protective elements.
Squeeze hard until you hear
the particle filter snap onto
the gas filter.
1.3 Check that you have
selected the right filter and
that the use-by date has not
been passed. (Specified on
the filter and is valid provided
that the filter packaging is
unopened.)
1.4 To separate a combined
filter, place a coin it in the
space between the lower lip
of the particle filter and the
small tab molded into the side
of the gas filter. Push firmly
and twist the coin until the
filter pops off.
To Next Page
Loading...
